[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Fuel System




----------
> From: Cory Erickson <ericksco@mhd1.moorhead.msus.edu>
> To: turbo@music1.moorhead.msus.edu
> Subject: Re: Fuel System
> Date: Sunday, December 21, 1997 6:18 PM
> 
> 
> On Fri, 19 Dec 1997, Dave and Mindy wrote:
> 
> > > > have you checked you bmap Hz it should be 159 at sea level
> > > > I think, I can get the 
> > > 
> > > Thanks,
> > > 
> > > BTW, this may sound stupid, but what is a bmap? Base Map? Hz? I'm
missing
> > > something here.
> > > 
> > > Cory
> >  
> > bmap is a barometric sensor (map sensor without a vacuum line hooked 
> > to it) HZ is hertz a frequency  measurement
> >  you measure it koeo
> > 
> > I found a TSB that says to check the intake manifold gasket to the
cylinder
> > head
> > it is prone to lamination separation and allows air leaks that are hard
to
> > find
> > install new gasket E59Z-9439-A 
> >  Hope this helps
> 
> Thanks Dave. I am pretty sure it's not the intake gasket, had that off a
> few times :). As far as the BMAP sensor, what do you use to measure it?
An
> O-scope?
> 
> Thanks,
> 
> Cory

  Cory you use a digital voltage ohm meter (DVOM)
one can measure HZ a good one (10,000 meg ohm impedance)
that is pretty much the standard in the auto industry

<DPlanakis@JNPCS.COM>
David Planakis 
advanced auto tech
7075-c newington rd.
newington va.22122
703-339-5500